H305 Black Soft Close Full Extension Drawer Slide
The H305 Black Soft Close Slide
The H305 is the black slide with the damper in it: three sections on a cage of steel balls, a module set into the inner member, and a plastic clip at the end. The damper is the part a buyer actually pays for, so the frames on this page are shot close enough to see where it sits inside the slide.
At A Glance
| Item | H305 |
| Material | Steel |
| Type | Three section ball bearing slide |
| Damper | Soft close module in the inner member |
| Mounting | Side mount |
| Finish | Black, bright steel also shown |
| Release | Plastic clip on the inner rail |
| Packing | Pairs |
The Damper Module
The damper is a sealed unit that sits in the inner member of the slide and takes over the last part of the closing travel.
- The module is set into the slide rather than clipped to the outside, so nothing of it shows once the drawer is in the cabinet.
- The slide closes at the speed the damper gives it, which is the point of ordering a soft close slide rather than a plain one.
- It is a sealed part: it is not meant to be opened, adjusted or greased on site.
Full Extension, Three Sections
Two travelling members inside the cabinet member mean the drawer comes out clear of the cabinet face, so the back of the box is reachable.
- Full extension puts the whole drawer in reach, which is what a deep cabinet is bought for.
- The plastic clip at the inner end lets the drawer be lifted off the slide.
- The travel of the slide is fixed by the section lengths, so the drawer box depth sets the slide length.
Two Finishes In The Frames
The frames show the same slide in black and in bright steel, which is how the part is ordered for two different cabinet interiors.
- Black is the finish for a carcass where the runner may be seen and a bright part would stand out.
- Bright steel is the same slide without the coating, for a cabinet that is closed all day.
- Both are the same three section slide, so the drawer box is the same whichever is ordered.
Fitting It
A soft close slide only behaves as it should when the drawer is square, because the damper is working against the last inch of travel.
- Set the cabinet side square and mark the drawer line before the first screw goes in.
- Fix the drawer member with the screws loose, close the drawer and let the slide find its line, then tighten from the back forwards.
- Push the drawer shut from a few inches out, twice, to confirm the damper catches instead of the drawer bouncing.
The Limits
This is a cabinet slide and it is sold as one.
- No length and no load figure are printed on the frames, so both are quoted on the order.
- The damper is made for a drawer that closes; a drawer that is slammed for years is a different question and worth saying on the order.
- A drawer that is stood in or climbed on needs a heavier slide than this one.
Ordering
The slide is matched to the drawer box, so the box depth and the length wanted are agreed before the pair is packed.
- Give the drawer box depth and the cabinet width with the enquiry, and the slide is matched to it.
- Say which finish, black or bright, because the pair is packed from the one line.
- Screws are quoted with the order if they are wanted in the same carton.
What Buyers Call It
The same part is asked for under three names, and any of them reaches this slide.
- Black soft close drawer slides, when the finish and the damper are both the reason for the order.
- Full extension soft close drawer slides, when the travel is what the drawing specifies.
- Soft close drawer runners, which is how the same slide is listed on European trade pages.
The H305 is a three section ball bearing drawer slide with a soft close damper module and a plastic release clip, in black or bright steel.
State the drawer box depth, the finish and the length wanted, and the pair is checked before it is packed.
Who Makes The Slide
The H305 is made by Guangzhou Gorgeous Intelligent Technology Co., Ltd. and exported under the Gorgeous Hardware name: three production bases in Guangdong, stamping, ball assembly and finishing in house.
The panels below are the plant and the paperwork behind every slide on this page.
Eighty Countries, Six Numbers
Three Production Bases
The Certificates, And What Each One Covers
Headquarters, Showrooms And Design
Where To Meet Us, March To December
Four Carton Options, And The Delivery Window
OEM, Brochures And Display
Frequently Asked Questions
Does it really close by itself?
The damper takes the last part of the travel, so a drawer pushed to within a few inches closes gently. It is not a puller and it will not pull a drawer shut from open.
Can the damper be adjusted?
No. The module is sealed and set in the factory, so there is nothing to turn on site.
Can the drawer be taken out?
Yes. The plastic clip at the inner end releases the drawer from the slide.
Is it available in bright steel?
Yes. The frames show the same slide black and bright, and the finish is fixed on the order.
Is there a load rating?
The frames carry no load figure, so the rating is quoted on the order for the drawer the slide is going into.
Comprehensive score