0
image
image
image
image
soft close undermount drawer slides

H630a Three Section Soft Close Concealed Drawer Slide

H630a
H630a is a three section concealed slide that runs under the drawer box: full extension travel, a soft close damper in the inner member, and a locking pin that holds the box on the runner, in pairs.
Country of Origin
China
Quantity:
Contact Now
add to cart
All Products

The H630a Three Section Soft Close Slide

The H630a is the top of the concealed range: three sections under the drawer box, a damper in the inner member, and a pin that locks the box to the runner. It is the slide for a drawer that has to open all the way, close on its own, and still come out when the fitter needs it out.

H630a three section soft close concealed drawer slides

At A Glance

ItemH630a
MaterialSteel, plated
TypeThree section concealed slide
DamperSoft close module in the inner member
ExtensionFull, drawer clear of the cabinet
LockPin through the inner member
MountingUnder the drawer box
PackingPairs

Three Sections, Full Extension

Three sections give two travelling members inside the body, so the drawer comes out past the cabinet face and the whole box is in reach.

  • Full extension undermount drawer slides put the back of a deep drawer in reach, which is the reason for paying for the third section.
  • The sections of the slide are stamped as one family, so the middle member lines up.
  • The travel is set by the section lengths, so the drawer box depth decides the slide length.

The Damper

The damper sits in the inner member of the slide and takes the last part of the closing travel, so the drawer goes in gently instead of dropping onto the stop.

  • The module is sealed and set in the factory, so there is nothing to adjust on site.
  • A soft close slide closes at the speed the damper gives it, whatever the weight in the drawer.
  • Where a plain slide is wanted on the same carcass, the two section slide in the range takes the same drawer box.
The H630a damper module inside the inner member

The Locking Pin

The pin through the inner member is what holds the drawer box on the slide, and it is the part that makes a three section slide safe on a tall drawer.

  • Locking drawer slides of this kind hold the box with a pin rather than a clip, so the drawer cannot walk off the runner when it is pulled hard.
  • The pin is released to lift the box off, which is how a finished carcass is moved with the drawers out.
  • The pin sits under the box, so nothing of it shows at the drawer side.

Fitting It

A concealed three section slide is set from underneath, and the damper of the slide is working against the last inch of travel, so square matters more here than on a side mount slide.

  • Set the cabinet square and mark the drawer line on both sides before the first screw goes in.
  • Fix the flange with the screws loose, set the box on the runners and let the slide find its line, then tighten from the back forwards.
  • Push the drawer shut from a few inches out twice, to confirm the damper catches rather than the box bouncing off the stop.
The H630a inner member and its locking pin

The Limits

This is a cabinet slide and it is sold as one.

  • No length and no load figure are printed on the frames, so both are quoted on the order.
  • The pin is a lock for the box on the runner, not a key lock for the drawer front.
  • A drawer that is stood in or climbed on needs a heavier slide than this one.

Ordering

The slide is matched to the drawer box, so the box depth and the length wanted are agreed before the pair is packed.

  • Give the drawer box depth and the cabinet width with the enquiry, and the slide is matched to it.
  • Say how many pairs; the two hands are packed together and quoted as a pair.
  • Screws are quoted with the order if they are wanted in the same carton.

What Buyers Call It

The same part is asked for under three names, and any of them reaches this slide.

  • Soft close undermount drawer slides, when the damper is the reason for the order.
  • Full extension undermount drawer slides, when the travel is what the drawing sets out.
  • Locking drawer slides, when the box has to stay on the runner until the pin is released.

The H630a is a three section concealed undermount drawer slide with a soft close damper, full extension and a locking pin.

State the drawer box depth and the length wanted, and the pair is checked before it is packed.

Who Makes The Slide

The H630a is made by Guangzhou Gorgeous Intelligent Technology Co., Ltd. and exported under the Gorgeous Hardware name: three production bases in Guangdong, stamping, ball assembly and finishing in house.

The panels below are the plant and the paperwork behind every slide on this page.

Eighty Countries, Six Numbers

Gorgeous Hardware world map of more than eighty export countries with six company statistics

Three Production Bases

Gorgeous Hardware factory gate and twelve production floor photographs from storage to container loading

The Certificates, And What Each One Covers

ISO 9001, ISO 14001 and ISO 45001 certificates with SGS, Intertek and RoHS test reports

Headquarters, Showrooms And Design

Guangzhou headquarters, hardware showroom, architectural display centre and design office

Where To Meet Us, March To December

Gorgeous Hardware trade show booths and the March to December exhibition calendar

Four Carton Options, And The Delivery Window

Four carton options from sticker service to OEM box and the six step delivery timeline

OEM, Brochures And Display

OEM logo on a hinge cup, brochure design pages and a branded display stand

Frequently Asked Questions

Does it close by itself?

The damper takes the last part of the travel, so a drawer pushed to within a few inches closes gently. It is not a puller and it will not pull a drawer shut from open.

What does the pin do?

It locks the drawer box on the runner and releases the box when the drawer has to come out. It is not a key lock for the drawer front.

Is any of it visible?

No. The slide runs under the drawer box, so the drawer side stays flat.

Are screws included?

No. Screws are quoted with the order if they are wanted in the same carton.

Is there a load rating?

The frames carry no load figure, so the rating is quoted on the order for the drawer the slide is going into.